Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Clara_Rios

  1. C

    Question about draft dimensions in CST microwave Studio.

    draft dimensions in CST Is it possible to have any "cutting plane" and associated dimensions y CST microwave Studio? Thanks in advance. Clara
  2. C

    antenna design using CST studio suite 2008

    cst 3d results antenna -mobile I am not an expert, but I will try to tell you what I have found out so far (I use CST Studio Suite 2006 but I think it's the same for 2008). Radiation Pattern: Look for Solve menu in the main manu bar, then choose Field Monitors and a dialogue chart will be...
  3. C

    CST-frequency domain solver

    I am working with rectangular waveguide to coax/microstrip transitions and some people have recomended me to run the frequency domain solver after having run the transient one. I would like to know how to manage with frequency solver menu and why it is important to run both solvers over the same...
  4. C

    SMA connector CST modeled

    I am trying to model and simulate the effects of a SouthWest Sma connector. Design is quite simple, two connector and a piece of coplanar microstrip. I don't know what I am doing wrong, but I get very bad results, very far from the desired ones. It is modelled in CST, I have checked boundary...
  5. C

    Simulating monofilar helix in WIPL-D

    ie3d vs. wipl-d Hi balaguru thavamani, thank you again. One more thing, you seem to know about WIPL-D, do you recommend it? al least for some applications? I guess that maybe is good for some specific use. The thing is that I have to give some final report about this software and I can say lots...
  6. C

    Simulating monofilar helix in WIPL-D

    wipl-d manual Hi balaguru thavamani, thank you for your answer, what I am looking for is some way of obtaining information about polarization and I have no idea of how to do it. In fact, I have no idea if polarization is available in any simulation software. Thank you very much. Clara
  7. C

    Simulating monofilar helix in WIPL-D

    Does anybody work with WIPL-D? I have been trying to simulate a monofilar helix and I would like to know if WIPL-D gives any information about axial ratio. If it is so, where do I have to search? Thank you in advance. Clara

Part and Inventory Search