Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It's the whole string of LEDs (half the lights, 20). The two wires in the picture are actually for the other string of lights. The one for this problem string is at the top of the board. So four wires all together, a black and a white for each string.
Not sure what you're asking in the...
But I have determined that it is not the switch by trying to light the other half of the lights with this same switch and they work fine. It's something from the wire that goes to the board (you can see on the bottom of the picture the wire that sends power to the board) and through the board...
Not sure this is where to post this as I am no electrician or know much about this stuff. I have a set of led lights that I use to light my aquarium with. Each led on the board has a small chip next to it which say "201" on them. The light has 40 leds and the whole board is split in half so...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.