Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: pic resets all time
I also have the same problem before.
Please check your LVP bit.
Enabling LVP bit will cause your controller go into low voltage programming mode.
Thus, you will see that your controller go "reset".
gcc or mikroc
Hi all,
For PIC, I personally still prefer assembly language for PIC.
Using assembly language, you can take full control to the controller.
For those who are familiar with C code, you can use assembler macro to make your code looks similar to C.
Besides, I found that assembly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.