Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Altium wrong variant information in schematics
Hi all,
in AD10 I have the problem, that my bom does not fit with the variant information shown in the schematics. Some parts are set to "fitted" in the variant but in the generated bom they are set to "not fitted".
After searching in the project...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.