Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, you may be able to "tune" the device for increased bandwidth. You can do this by drilling and tapping holes into the waveguide wall and inserting screws. Once the screw is in, adjust the screw height to optimise performance, then lock the screw off with a locknut. In-line with the probe...
Hello, I need to find a quantity of 5-10 pieces 50 ohm N Male connector, mounted on a 4 hole 1" (25.4mm) flange. The connector must be passivated stainless steel (not brass) and must have the 13/16" hex coupling nut (not knurled). The connector is fitted to a naval radar, so has to be very high...
I have a problem in that a circulator appears to be adding noise into a system above the measured value of the circulator's insertion loss. I do not think that the problem is related to compression under power. The circulator is designed to handle the power specified for the system.
It has been...
Re: circulator buy?
Are you still looking for circulators? I should be able to help if can advise frequency range and style of device you need, i.e. waveguide, coax connectorised or coax drop-in. Please post reply to this forum.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
