Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Use phase A as a reference.
Measure the time interval from phase B going positive to phase C going positive.
That time interval will be different for forward and reverse rotation.
Hi Warpspeed, thanks for that.
I spent the whole afternoon fiddling with it and I had some success by changing the value of the timing cap discharge resistor. Was using zero ohms with 1nF which should have been alright according to the datasheet, but now I have 390 ohms and there is a tiny...
Hi all.
I have an interleaved voltage-mode boost converter that uses both sides of a SG3525 to drive two MOSFETs in anti-phase for use in an automotive environment. Inductors are off the shelf 220uH powdered iron toroids. Input voltage is nominally 12V and output can vary between 15-25V. Output...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
