Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
i need some help on the command below.
parameter [7:0] screen [0:7] = {8'h01, 8'h01, 8'h02, 8'h03, 8'h04, 8'h05, 8'h06, 8'h05};
the following command always show the error
Error (10709): parameter with complex/aggregate value must have a type
please advise.
those opamp do not have supply pin out. We need to double click inside the properties and set out supply there. The text file do display the supply value (+/- 15V).
I have try out a few option provide from the forum eg. STEPGMIN, increase ITL1=400, changing OP-AMP open loop to 1e-5. Attached is the schematic and hope someone will help.
Appreciate any help given.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.