Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Anyone has any experience with this?
I hate to make the board, have the SMT component soldered, only to find out later that it can not be separated! That's why I want to be 100% sure.
Due to the space limitation, I would prefer not to use an extra power supply board.
The current is low, I am using a CR2032 battery to supply the power.
What are my choices?
Thanks!
Hi,
I am putting several small boards into one PCB (FR4) with V-cut in between, just wondering whether I can easily separate them by hand after the SMT. If not, is there any readily available tool (for example, some type of knife) that can do the job? Never did this before, anyone has any...
Hi, need to connect several small board to one power source, what is the best connector to use to connect all the boards in serial to the power supply? I.e., Vcc and GND to board A, then board B, then board C, ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
