Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am a bit lost about how to establish the parameters to establish differential pair routing. I am currently trying to route several differential pair and I am a bit new to this. I have searched online some tutorial but I don't find any really explaining **easily and out of the theory** with...
I have two questions in one:
I have collected some schematic from datasheet from manufacturer of chip. Inside the datasheet there are the following circuit shown below.
1./ The manufacturer don't provide the BOM, so I don't have part number for all those small passive components. How to...
I am curently working on a project where a MCU got only one UART port available, however I need to run two peripherals with UART interface (not simultaneously) so I was wondering if I can connect two peripherals UARTs on the same UART of the MCU while playing with enabling and disabling the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
