Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by chr0n

  1. C

    PIC16F877A Timer Question

    pic16f877a timer I am using an temperature sensor on the PIC16F877a and im updating an LCD screen every minute.. I was wondering what i had to set my timers to, to have interrupts every minute to update the screen with the temperature. Im using a 20Mhz clock and whichever timer...
  2. C

    Question about MCP3905

    mcp3905 Just got the board in. Still wondering if anyone has any experience with it.
  3. C

    Question about MCP3905

    mcp3905 Hey guys, Just wondering if anyone has any experience with this IC. I was wondering if it would be possible to use this along with the PIC16F877A to get True RMS Voltage, Current and Power. I've never used it before so any info from someone who has used one or knows about it would...
  4. C

    Simplest way of measuring and displaying 120VAC using PIC16F877A

    Re: PIC16F877A Question sure, could you provide a simple block diagram or schematic on how to set this up to explain a bit? thanks.
  5. C

    Simplest way of measuring and displaying 120VAC using PIC16F877A

    If i wanted to measure and display 120VAC (Voltage, Current, Power, AC Wave, etc...) from a receptacle in my house using a PIC16F877A. What would be the most economical and simplest approach? This is for a class project so I was just curious.
  6. C

    Rectifying for Comparator Op Amps/PIC

    If I want to recitify 120VAC to VDC for comparator op amps and send out a signal to a pic to turn on a DC Relay. How would I go about doing this with a bridge rectifier (what size or types of components) and what would the calculation conversion be to calculate how much VDC it will be rectified...
  7. C

    Automatic Transfer Switch Project with Microcontroller

    I would have the windmill going into a comparator Op Amp that will send a +5V signal or -5V signal out depending on the voltage coming in. So my basic understanding of how it works is that; If Windmill >= 120VAC then the Op Amp will send out +5V If windmill <120VAC or so then the op amp will...
  8. C

    Automatic Transfer Switch Project with Microcontroller

    Hey guys, For a school project we are building an automatic transfer switch system that will switch between Hydro power and another alternate AC source, in our case a windmill. Basically what we want to accomplish is we want to feed power from hydro and if our windmill is supplying enough...

Part and Inventory Search

Back
Top