Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Normally it's connected with a 12 pin flat ribbon cable
I believe the pitch is 1.0mm and it has 6 solder pads on each side.
Isn't it easier to just replace the socket with a new one?
Hello,
So recently ive dismantled my ps4 controller and when i heated up the back side of the circuit board a socket got too warm and melted and now the connector cable doesnt fit anymore in the hole. Ive been searching all around the internet for the loose component but i cant find it.
Can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.