Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My LCVCO is converging .i.e. starting when I am not checking any transient algorithm. In this case, I am getting the required tuning frequency.
But when I turned on gear2 or gear2only algorithm, then my LC is not starting for any vcontrol signal. The oscillations are getting damped.
The same...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
