Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi I am designing Microwave cavity Band Pass Filter can u suggest me reference paper for that. Any designing will do e.g. Iris, Post, Combline etc.
Thank You.
Dear KMPA
Need some help about resistors in HFSS. i want to use Flange type resistors in my power divider so how should go with that & how the connection between resistors & impedance lines built up in hfss???
Thank You.
Hello,
I am implementing Power divider using stripline. I have used lambda/4 = 75mm (1GHz) & air as a dielctric material. My question is that suppose i want to implement 57ohm line so to find out width ill first terminate it at 57ohm then see the reflected impedance if both are same then it is...
Hey seen your hfss file. You have not assign any material thats why your getting different results. Also for radiation, gain pattern you have to insert radiation box or sphere that will help you in calculation of gain.
All the best:)
Hi friends.
Need some help about resistors in HFSS. i want to use Flange type resistors in my power divider so how should go with that & how the connection between resistors & impedance lines built up in hfss???
Thank You.
ggilmore
I am implementing power divider using striplines between two conductors in air medium so how should i go with placing resistors. If u have done that just post image of ur model.
Thank you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.