Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would like to simulate spiral inductor with different materials using ADS (other software is also welcome)
typically the conductor is perfect conductor. So how can I change the conductor property? Particularly I want to change the permeability of the conductor.
Shall I add one more layer and...
actually I found my problem.
The reset pin should not be floated.
However, currently I am working on the calibration.
the AENERGY and RAENERGY registers I have read are quite small, only in 0x0189~ 0x489
here is my current setting:
0x09, 2, 0x00, 0x81, 0x03, // Mode,
0x0A, 2, 0x00...
ADE 7758
hi I am working with ade7753.
Can you send me your spi code? I could read the registers, but the writing seems unsuccessful.
Can we share the experience working on ADE chips?
BEST!
you can easily use voltage divider to sense voltage below 5V.
For current, you may use a shunt resister or transformer (also good for voltage sensing).
HI ALL
I have a project using ADE7753.
Right now I am trying to write the registers inside ADE7753 with atmega168 microprocessor.
I modified some SPI code online and I do use oscilloscope to check the write and read sequence.
But the strange thing is that all the signal sequence looks fine.
I...
HI ALL
I have a project using ADE7753.
Right now I am trying to write the registers inside ADE7753 with atmega168 microprocessor.
I modified some SPI code online and I do use oscilloscope to check the write and read sequence.
But the strange thing is that all the signal sequence looks fine.
I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
