Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Chandan_333

  1. C

    skill- layer replace in a bounding box

    thanks! But how to do this please explain...as I am a beginner in skill...
  2. C

    skill- layer replace in a bounding box

    How can I replace a layer with other one in a defined bounding box area? please share...
  3. C

    Spiral antenna simulation in HFSS

    Thanks hosein_rabiee_g for your quick reply. How can i identify polarization by comparing LHCP and RHCP Gain? Have i also check LHCP & RHCP to identify vertical/horizontal polarization. And how to check dual polarization? Thanks again.
  4. C

    Spiral antenna simulation in HFSS

    Re: spiral antennas Thank you very much for your reply. Can you please explain in detail? How would i know the antenna i have designed is vertically polarized/horizontally polarized or circularly polarized relating to polarization ratio pattern in hfss.
  5. C

    Spiral antenna simulation in HFSS

    Re: spiral antennas Please, do you know how to find the "Polarization" of an antenna after HFSS finishes simulation ?
  6. C

    Antenna parameters in hfss.

    How to find out polarization, cross polarization, axial ratio and isolation in hfss? If anybody knows please help. I am designing a RCH Antenna.
  7. C

    Polarization, Isolation in hfss?

    How to find out polarization, cross polarization, axial ratio and isolation in hfss? If anybody knows please help. I am designing a RCH Antenna.
  8. C

    Polarization, Isolation in hfss?

    I am designing a corrugated wave guide horn antenna.
  9. C

    Polarization, Isolation in hfss?

    How to find out polarization and isolation in hfss?
  10. C

    how to reduce vswr in hfss design of waveguide?

    Anybody please tell me how to reduce vswr of a waveguide in hfss design. I am designing a horn feed. If anybody know please help...
  11. C

    how to generate higher order modes.

    How to generate te20 and te11 modes in a waveguide? is the waveguide need to be square for this?

Part and Inventory Search

Back
Top