Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I solved problem. when i upgraded angstorm to wince, downloaded damaged and wrong file. that's why i think it couldn't start up with necessary files.Because i changed them.
I installed all angstorm files to SD card and powered on with it. I loaded system from it and it works fine.
That problem has been after when I tried to load wince system to the Nand flash. Firstly I chose 2. or 3. and it's about 'erase' , after that I upload files from SD card and xldrnand wasn't in sd. It couldn't copy too. After that board hasn't work again.
I can't communicate with board on COM...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.