Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I'd like to know how can i choose what type of surface mount resistor(carbon film, metal film, .......) is the best for my application, I'm dealing with analog signals, and don't need more power than 1/4W. i'm searching at digikey, but i don't know how to decide, if somebody has any idea, or...
Hi, I´m looking for an example code using the ADC of the 18F242 pic, because I have the tried with the datasheet instructions but I had no success.
thanks in advanced.
Re: LEDs
You can do it, but depending of the use of your circuit, and the leds characteristics, you'll probably want to adjust the leds bright, because of the diference in the impedances, and you'll have to add some resistors to your circuit.
Re: digital camera design
1. About interfacing a CMOS image sensor and a PIC microcontroller.
Inteferfacing depends on the sensor. Normally image sensors are quite faster, 8bit@19MHz. You should have a very fast microprocessor, if it is a PIC, do not think about real time, maybe if you lower...
I don't know much about MathLab, but here is a tip for ANY antenna gain pattern data set (or plot):
The average gain (far field) over the entire sphere should be 0.0 dBi (or pretty darn close), not including any losses that might be included. This common sense rule applies to both mathematical...
Radioastronomy Antennas
i would like to know, what type of antennas are used in radioastronomy, and what technology is used to transmit signals to space
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.