Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by celhedo

  1. C

    propagation delay of a system

    Dear all, I am having problem with the timing analysis of a system.I am to find the overall propagation delay of my design using quartus 2...what is the best way to find it using modelsim,times quest...or any other software. I am open to suggestions. Thanks.
  2. C

    Problem with modelsim/Quartus 2 web edition 10.1

    solved already,thanks.
  3. C

    Problem with modelsim/Quartus 2 web edition 10.1

    Hi, i am trying to run my testbench using modelsim but i am getting the following meassage: --------------------------- Nativelink Error --------------------------- Can't launch the ModelSim software -- the path to the location of the executables for the ModelSim software were not specified or...
  4. C

    FIR FIlTER DESIGN using fir1 funtion in matlab

    Hi, I've been working on designing an fir filter,with the following specifications: Sampling freq:10K passbannd range=0-2MHz stopband range=4k-6khz. I've been trying to use the fir1 function,but the message is frequency should be from 0 to 1. How do i solve this? Thanks.
  5. C

    How to get the value of a resistor using ADC in PIC16f690.

    Re: How to get the value of a resistor using ADC in PIC16f69 Thanks for your reply. I'm using a voltage divider.The problem is the code.Extracting the value of the resistance and displaying it on 7segment led(x4). I'm having problems with outputting my measured value. pls help.
  6. C

    How to get the value of a resistor using ADC in PIC16f690.

    Hi all, I'm working with PIC16F690 using C language and Mplab.I am new with with ADC.I need a code to output the Value of a measure resistance.My output is in portC,connected to a 4x7segment LED. Thanks.[/b]
  7. C

    PIC16f690-multiplexing 7 segment ledx4

    Re: PIC16f690-multiplexing i'm working with C language using mplab
  8. C

    PIC16f690-multiplexing 7 segment ledx4

    PIC16f690-multiplexing I'm new to pic and having a problem understanding software multiplexing.Please i need help(code) to multiplex 7-segmentx4 on port c.I'm using c language and mplab I'm using mplab. thanks alot.
See more

Part and Inventory Search

Back
Top