Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to add that ripple should be around 40-60Khz (sw frequency)
I was thinking to have the sweep time to 10s , RMS detector on and 0 DB attenuation
RWB at 15Khz , measurements in FFT , VBW at 100Khz
Bandwidth 9-900Khz
Hello
I have a SMPS and would like to measure ripple and noise from 9Khz to 100Khz using a spectrum analyzer.
So I have a DSA 875 from Rigol that can measure from 9Khz and up.
This is the first time I am using a spectrum analyzer and I have no idea what to do. Should I use a capacitor in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.