Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by cdbular

  1. C

    Help me on Differential Amplifier

    Schematics and simulation screeshot would be useful
  2. C

    Question of phase plot init point (180 vs 0 deg)

    Question of phase plot it depends which input you take as reference. As edge_tv said, when the phase starts at +180 is because you are using the inverting input as reference for the AC analysis.
  3. C

    Fully Differential Folded Cascode OTA With SC-CMFB design

    ota cmfb design I made a Verilog A model switch and replaced MOS switches with this model. Basically the ideal switches wor like a voltage controlled resistance, with very low resistance when activated (200 omhs), and a very high resistance when off (10Gomhs).
  4. C

    Fully Differential Folded Cascode OTA With SC-CMFB design

    folded cascode ota I attached the images of the schematic and the simulations. When using the MOS switches the CMFB voltage varies in a much wider range. As you can see in the simulation screenshots.
  5. C

    Help with FD folded cascode OTA with SC-CMFB

    Hello, I have designed a fully differential folded cascode OTA with SC-CMFB. I haver tested the circuit using a SC-CMFB network using Verilog-A macromodel switches. And the OTA seems to work very well. When I replace the switches with transistors the clock injection is so bad that the CMFB...
  6. C

    Fully Differential Folded Cascode OTA With SC-CMFB design

    sc cmfb Hello, I have designed a fully differential folded cascode OTA with SC-CMFB. I haver tested the circuit using a SC-CMFB network using Verilog-A macromodel switches. And the OTA seems to work very well. When I replace the switches with transistors the clock injection is so bad that...
  7. C

    Looking for materials for Motorola programmer

    Motorola programmer? Where can I find any motorola microcontrolers programming hadrware schematics, simulator and compiler :?:
  8. C

    How to make RS232 interface in C/C++?

    How to make RS232 interface in C/C++?
  9. C

    80C51 programming hardware

    80c51 programming Couldn't find it
  10. C

    What is the replacement for GAL chip ?

    Re: GAL and FPGA GALS are oudated but are still useful to make simple logic systems. FPGAs are a lot more complex, you can even run Microprocesors on them.
  11. C

    What are the applications of opamp 741?

    automatic gain control opamp 741 is a general usage AMP OP, nothing special about it, for specific applications reuiring low noise and low distortion, other kind of aplifiers are required.
  12. C

    80C51 programming hardware

    80c51 programmer Where can I find 80C51 programming hardware schematic circuit and software? I need to buid the programmer for a project

Part and Inventory Search

Back
Top