Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How about the switching loss that occur on the mosfet?
I can't use ferrite for the material can i? as long as i reading about it, it should be air gapped material.
Yep more or less, unless i design it for 180 Vac input so the rms will be on 8.87 amp rms.
can you give me any practical theory...
I intend to design an 1500W PFC using ONSEMI's NCP1654 working on 65 kHz, below is the schematic design
The design i intend to is working at EU input with 400V output.
the parts that left for design is the inductor. I trying to design the inductor using example at A-Z SMPS by Maniktala on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.