Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This project is mostly relays and wiring. I used to work around big motors. The control circuits for these consisted mainly of relays (ice cube relays). That's the level of sophistication I am at. I'll be bread boarding mainly with relays. Small electronics, and components can come later...
I'm wondering if you got your messages mixed with someone else. Clamps, HDMI, coupling capacitors, Femptofarad, 12c...I don't know what these are, and they seem to be not associated with this project.
I'm back. I am calling this my "Compass Project". Voltage: Overall, there will be a number relays and relay contactors involved. I would like to think all this needs to operate at the same voltage. I keep seeing 3.3vdc come up. The final product output I will amplify to 12 vdc for a horn and...
Wow. Got lost. There is some wriggle room in the accuracy. Actually, I'd like a component that I can dial in these numbers to tune it to a good operating range. It will go on a boat that anchor's "out in the stream". Its a long story how this came up, and yes, I know Garman and many others...
HA! Thank you for replying. I was not really expecting a reply, especially this soon. It is going to be an anchor warning device. I want to create an output signal that if the device changes direction by 8 degrees for 8 seconds, an output signal is activated. The little research I've been...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
