Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: calibre LVS problem.
Might be the calibre deck is not recognize the metal pin layer for lvs.
You can use the metal text layer instead of pin text layer or review the deck the which text layers are the deck used for LVS.
some example shown as below.....
TEXT LAYER 131 ATTACH 131 metal1...
dracula calibre
Hi,
The Calibre can treat the check(LVS/DRC/ERC...) in hierarchy or flatten mode which you want to, rather than Dracula only in flatten mode. The Calibre run time in hierachy mode is shorter than flatten mode because its treat the check once when meet the same cell name in...
anteena diodes
Hi,
If the violations number is not large, you can change the metal route layer to solve this problem. (prefer to change it as upper level metal/via layer)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
