Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks a lot !
I compared with my code, and I figured out where ther erro was.
First = I did a mistake here : T1CON = 1000000000000000 -> correct is T1CON = OB1000000000000000
Second = PR1 = 0; I can´t put zero value here...
Thanks again my friend !
Hi !
I am using for the first time PIC24, programming in C and using MPLab + Hitech.
I do not know why, but I am not getting the interrupt work. I put a breakpoint inside the interrupt, but seems it never comes inside...
Someone could help me, please ?
My code:
Setting:
//----- TIMER1...
Re: Ground Plane
This board I doing now, has a Microcontroler, a Operational Amplifier and Optical Isolator.
Well, I have been doing the ground plane on top and I have never gotten problems, but now I wonder if I was doing right.
When you all said both, you meant that side doesn´t matter ...
Hi all !
Could anyone tell me where the best location for ground plane is, when I am using 2 layers only? (Bottom and Top).
Thanks
Added after 47 minutes:
I meant what is the best side to make the ground plane, Top or Bottom.
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
