Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i dont think dats d process....as far as i know...in IE3D finite ground plane is only possible by setting real part of conductivity of 0 layer to 0 and den d process i mentioned before....
regards
you must be having different substrate layers...select the bottom layer after you finish your structure and connections.....draw a rectangle in the bottom layer with desired dimensions such that it contains the struct....then give the dimensions......
if i have to include a normal lumped resistor in microstrip structure how do i proceed...could u tell me the steps plz....dat would be really helpful.....
i m tryin to simulate a wilkinson power divider in IE3D software...but have no idea how impedance matching is implemented in strip lines.....can somebody help plz
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.