Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I assigned the terminals manually, but now I get the following error: "Too few conductors were found on port 1. There should be one conductor for each terminal, with one additional reference conductor. Unintentional contact between conductors may cause this error.". I dont know why because...
Hi,
I need to simulate the impulse response of a microstrip in Ansys hfss so I am using the transient solution type. But i dont know how because when I create the wave port, as in frequency simulation, I get the error "The port has no terminals defined on it".
Thanks to all.
Camilo
Student...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.