Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In Proteus I'm using LCD LM020L. I would prefer not to use a RTC, cause I don't need date, the system will be used once a day. I was planning just to use tmr0 with interruption, and there is where my problem starts. I can't figure out how to configure the tmr0 and use interruptions.
Hello,
I'm doing my final project graduation and using a PIC to make a clock with alarm. I'm gonna use too a 4MHZ crystal and an 16x2 LCD. The compiler is mikroC and I need a little help for how to read the oscillation of the crystal and use this in my code. If you have any codes example with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
