Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The board is a Yuneec CGO3+ gimbal board. It controls the camera/gimbal movements. The filter choke actually broke off from the board. I have been researching it all day and this is what I know, so far.
It is a Ferrite type surface mount common mode choke.
It has 4 points that contact to the...
Yes, it has 4 spots where it attaches to the board. The copper wiring was also attached somehow. I removed one from another gimbal board I had and it seems to be good. I really need to know how to do it. I am decent when it comes to soldering.
Hi everyone,
I am new to this forum but I feel I will be here a LOT. I am a circuit board hobbiest and also a drone pilot. I am currently trying to repair a gimbal on one of my drones and have ran into a problem. I have no idea what I am doing! lol
I have all the needed equipment to micro...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.