Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks alot.
I still have one confusion for Input current for logic low for (74ls IC) I_IL = -0.6mA it is written under the column MAXIMUM. So, this value of current remains (neglecting slight variations) if we use less than 1k ohm resistance down to zero or this value I_IL can change (e.g...
Hi,
I am conducting Digital Logic Design LAB. I have taught them using pull-down resistors giving inputs to gates. But there is one confusion i have when giving an input (e.g., label A) to multiple gates' ICs can i use a single pull-down resistor or should i use separate pull-down resistors for...
Hi,
According to my knowledge, for inputs to the 7447 IC, the input current to the IC inputs should be zero.
WHy we use parallel 10k resistor with the supply voltage when giving inputs to the 7447 IC as in the figure below?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
