Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Analog would be preference, but if too complicated, digital would be fine too.
Voltage and current is not quite applicable, as it effectively checks connections in the cables and some cases diodes, so ~5VDC is more than enough.
Timing is not too critical too.
Hello all,
Looking for people opinions on how to implement embedded solution with 250+ IO's.
The system would work in such principle that one pin is set to output while all others are inputs. Then it changes to next pin being output and all others inputs.
Looked at IO expanders and...
To make it clearer, I have attached picture of current PCB size. Any chosen design would have to fit within same dims as I have lots of enclosures (and they were costly).
So from what I see it may be much easier to just find much better design voltage regulator. Anyone have a source of 15-30VAC to 15VDC voltage regulator? Must be very compact..
You are right Brian. This is normally driven by engine's alternator. I am aware of missing output capacitor. The challenge is to either improve current design using today's solutions and parts (I would expect it would be cheap too)
Any suggestions? :) Main point being it has to be very very...
Hi all,
Here I have a project for voltage regulator. This is designed to use in small boats where you would need 12v dc power supply for ancillaries.
It's not a perfect design and sometimes I get various faults, some of them are mystique. If someone, who has more experience with voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
