Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
p89c51rd2 isp program circuit
Hi guys. I am designing a programmer for the P89V51RD2. Now i am going to program the microcontroller using the Rx, Tx pins only. Since im not goin to use PSEN should i leave this pin floating or connect it to +5V or GND?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
