Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have a 27.148MHZ TX system I am transmitting an AM signal from to an attenna. Currently if I measure the power out of the TX system with a spectrum analyzer than I am getting approxamtely 30dB at my carrirer signal. So have hooked up a whip attenna speced out at SWR around 1.8-2 at...
So I have about 6 cell phone litium ion batteries rated at 3.7v each. 3 are rated at 1000mAhr and 2 950mAhrs. So I understand all these ratings and what they mean. But is there a max current draw I can get out of these batteries. I would like to be able to drive two small motors. I think I will...
FDP8896
N-Channel PowerTrench® MOSFET
30V, 92A, 5.9mΩ
Does anyone know if they make a p channel equavalient to this mosfet? Through hole if possible.
Thanks
I'm wondering how to important spice code into a model file. Next, I want to be able to take that model file and create a block in Pspice that I can use. I have student version.
My Specfic problem: I have spice code from data sheet:
.SUBCKT FDD8880 2 1 3 ; rev April 2004
Ca 12 8 9.5e-10
Cb 15...
Question about the frequency domain solver. When I open up the Frequency domain solver parameters windows, where I can specify 'excitation settings' and such, there is a section called excitation where you can specify the excitation port and mode. I had been using floquet modes for a while, and...
When I'm not studying my arse off for exams I actually try to take a trip somewhere. Some pictures of the new Yankee stadium in NYC for anyone interested if you have never been to NYC or America. See pictures.
If you guys are from other countries please send pictures.
its not fully resistive though. The power factor is not 1. Right? Isn't there some Vars to the load. So I could use relation S=VI* to find I. Where S is the load power and V is the power across the load.
Thanks for staying with this.
Hi, I was just looking over the different groups and noticed there were no groups for students or learners of the trade. Since most of us will be inevitably studying similar things I thought it would be useful to bounce knowledge and ideas of each other. In addition, I don't know how many people...
I have a question about the wording of transformer probelms. See diagram
So the question says:
A 1 phase 3kVA 240/120V 60HZ transformer has a feeder impedance .75+1.17j.
So the question says:
Determine the voltage regulation when the transfomer is supplying full load at 110V and .9 leading...
Just want to make sure I'm on the same page with CST. But, when using periodic boundary conditions, in the template for FSS, TM refers to p-polarization efield along x direction while TE refers to s-polarization E field along y direction? Where y and x directions are referenced to CST.
Also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
