Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey everyone
For the meantime we decided to try the solution summitville offered, a dedicated IC: LT3083 & LT3086.
I will update in any changes or progress I will make in them or in the other circuits.
Thanks for the help!
Hey
Here is the simulation I ran:
The graph is the Iload vs V1 (Input)
I think the problem is with the transistor and OPAMP I chose? I will try to simulate again. Thanks!
31crutschow, Thanks. I will try it as well.
Hi,
Thanks for clarifying.
I looked on your tutorial and tried simulating it at LTSPICE and didn't get any results.
I'm still reading about it in various sources.
The things I see the most are an OPAMP in which the output is connected to a transistor (BJT or MOS) that opens the current for the...
Hey all!
Thanks for replying.
I'm currently working on specification.
All I know for now is that the control voltage should be 0-5V OR 0-10V, preferably to 0-5V.
About a block diagram- attached
Klaus, What does it mean high side or low side?
Thanks again. I will try and go through similar...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
