Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I went about it slightly differently then coding the handshake, but perhaps this will help.
I connected the RTS pin to the CTS pin, making the device tell itself that its good to go.
I also connected the CTS pin to an analog input on an Arduino micro controller.
In the code while...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.