Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
SVHB - In the end, our assembly house addressed the situation. They told me they had to enter every component by hand, and it took a whole day. After reading the posts in this thread, I'm not sure exactly why it was so complicated. I presume it simply meant doing things differently than usual -...
Thanks everyone for the useful comments.
Mattylad - Yes, we do have ther gerber files.Graphicodes GC-Place seems like a good tool for this. I will recommend it to our assembly company. However, it's pretty expensive and I'm not sure if they will purchase it just for us.
We use Altium Designer...
We designed several PCBs (7) using Altium Designer, and sent the gerber files to a PCB manufacturer, who merged them into a single panel as per our request.
Afterwards, we sent the resulting panelized gerber, and a single BOM, but 7 separate pick and place files to the PCB assembly company...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.