Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: +/- 5V power supply.
I have a question about part of this.
The datasheet for the 3FL16-350 Shows pin 1 & 3 together and 2 & 4 together.
But in the datasheet Pin 3 is the last one and pin 4 is the third one, as with the out put 5 & 7 are on the ends and pin 8 is the third one.
1 5
2...
Re: +/- 5V power supply.
I just got all pieces to put this together.
It keeps blowing the fuse. Any suggestions were to look?
I have pins 1234 on the AC in.
Thanks
Bob
Thanks, but I was hoping the guy that posted one some time last year that I'm not able to locate would catch the post.
This is just for hobby exposure. I calculated the time/distance and they are doing ok. Someone mentioned
to find a test strip to be sure. They said there was plenty of DIY ones...
Decided to start doing my own PCBs. Toner worked great. I decided to start using
negative photo resist. I've been getting different results and was told I want to create
a test strip to find the correct exposure for my setup.
Google doesn't seem to return many results with designs that can be...
Re: +/- 5V power supply.
Ok thanks. I'll see what I can do. I'm not sure the viewer will let me do that but I'll find a way to work with it.
Thanks again
Bob
Re: +/- 5V power supply.
Hi mister_rf,
Thank you for this.
Is there a chance you could put this in a .lay file? I have a couple small heat sinks so that's not a problem.
Thanks
Bob
---------- Post added at 16:27 ---------- Previous post was at 16:19 ----------
I do have pictures of the...
Re: +/- 5V power supply.
Thank you so much. This will give me something to work on.
All I have to do is figure out how to get this on the PCB board.
Thanks again
Bob
Need help from someone that knows PCB design and can work with a .lay file. I was given a pcb file (.lay file attached in zip) for a power supply and needed a transformer to tie on to it.
I have a 3FL16-350 Tamura datasheet is attached also that I was told would be an excellent choice.
I don't...
In your V3 it has a SPL7 file and hex file. layout50 does not open it or see it. sPlan70_Viewer opens it but it's not PCB just schematics.
I must be totally doing something wrong.
BTW, what registered version of what software should I work on saving up for. I see so many of both Eagle, and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
