Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Awesome, I really appreciate the info from both you.
Worst case I buy a new saw, but am hoping this works since I gambled initially buying a saw with a faulty switch in the first place (75% off).
As luck would have it, repairing the switch was simple, but I seem to have made things worse in...
It sits maybe 4" away from the board next to the motor.
In the pic I've attached, the red rectangle is the location of the module, and the grey wire runs to the component, which is inside the red circle.
Thanks for replying! This has been driving me crazy and bosch tech support has been no help.
Can someone identify the component at the end of the grey wire? The little resistor looking piece attached to the white rectangular PCB.
I accidentally smashed it while attempting to fit the components into the plastic housing after replacing the brushes, and now whenever the switch is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
