Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to close up this thread for future searches. I ended up experimenting with a small ic/solid state relay. It seems to be working perfectly.
Thanks for your help.
Albert, thank you for taking the time to help find a solution to my issue, However, you still don't understand what I am trying to do.
The way CAN transceivers work is you connect CANH and CANL to the bus and then connect TX_RX to your CAN controller. I have several controllers and transceivers...
Thank you for responding Albert.
I have mocked up a basic diagram showing what I need. The CAN transceiver is not applicable because the issue is not about controlling the flow into the MCU. I need a mechanism that will allow me to break the connection of another node from the bus.
Any...
Hello guys, I am new to this forum and this is my first post.
I am in desperate need of some advice / direction regarding a circuit design problem I am trying to overcome.
I need a mechanism, preferable a suitable IC or suggestions on a combination of transistors to allow a microprocessor to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.