Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I suggest you download the datasheet for the two cards. I strongly suspect you will see that the ID commands are identical "0x26", 0x52" and from this you will be able to see which card you are talking to
Firstly have you downloaded the Microchip TCP/IP Stack? This should get you up and running and I suggest you use a PHY that is already supported, or is electrically identical. You should only use one PIC for this.
rf transreceiver spi interface
Hi Im also developing a system using a MSP430F and a Chipcon chip. Although I have got the system working in the fact that one unit transmits and the other recives I can not get each unit to switch. I.e the TX-RX and RX-TX switching does not work. Any ideas...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
