Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am looking for a IC or circuit to AM 150MHz Carrier(<5dBm),AF is 350~2500Hz 400mv .M=0.9 Distortion<1.2%.
The output AM signal Distortion<2%
who can help me,Thanks.
Re: Question about balun
Thank vfone, chaoFan.
May you tell me what is the different between this balun and the balun(T4&T5) as following fig?
the mosfet is UF28150J of macom.
Question about balun
Hi All,
Does anyone know the balun(T2&T3) in the following figure is 1:4 or 1:9.
the fet is D1009UK of semelab.
Thank.
[url=http://obrazki.elektroda.pl/37_1250860689.jpg][/
Thank VSWR,FVM.
I hope to read the book Transmission Line Transformers,May you email the ebook to me? my email is liok802000@yahoo.com.cn
Thank.
Added after 29 seconds:
Thank VSWR,FVM.
I hope to read the book Transmission Line Transformers,May you email the ebook to me? my email is...
1/6 transformer
I want to design a high power(200w CW) directional coupler as following circuit,It work over the range from (30~80)MHz.
I am going to use a 3:5 voltage ratio transmission-line transformer as a 1:3 impedance ratio transformer.
However I don't know how to design 1:6 impedance...
Re: What's the function of this part in a RF power transisto
Hi chaoFan
Can you give me some directly help with email?my email is liok802000@yahoo.com.cn
Thank.
Added after 50 seconds:
Hi chaoFan
Can you give me some directly help with email?my email is...
Hi chaoFan
what is OBO?
Thanks.
Added after 3 minutes:
Hi kspalla
Which pre-distortion circuit is suitable for my amplifier?
May you give me a circuit?
Thanks.
Added after 31 seconds:
Hi kspalla
Which pre-distortion circuit is suitable for my amplifier?
May you give...
Re: What's the function of this part in a RF power transisto
Hi chaoFan
the L-C is inside the package.But I have on idea of how the L-c match the device.
Have some book or paper about it?
Thanks.
how to improve an amplifier
I design a amplifier
f:(30-400)MHz
Pout:>25W(CW) @IM3<-25dBc
The circuit and picture as following:
the Mosfets are two MRF9045.
the amplifier's IM3=-26dBc@270Mhz@25W(CW)
but the amplifier's IM3=-18dBc@400Mhz@25W(CW)
How can I improve the IM3?
thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.