Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am in New York, just outside New York City (Great Neck). The posted picture I put up was from a website. The actual switch says sw302 on the circuit board but I guess that is not important.
Am I correct that the switch is a SMD Tactile Tact Push Button Micro Switch 6.2mm x 6.2mm as the specs...
Thank you for the reply. I was able to remove the front panel and get at the circuit board. The start print micro switch is the problem. Do you know where to get a new or refurbished control panel for this copier? Refurbished is preferred provided it has a guarantee not to arrive DOA.
BradTheRad, thank you for the reply. I will consider that suggestion.
If that doesn't work and I have to solder a broken wire, how do I open the panel to get at the start to print button?
Update on the machine's use: Periodically, when you put on the machine and press on it (sometimes soft...
PROBLEM: Have a Canon C130 copier. It is very hard to get the start key to print copies. You have to press real hard, sometimes pressing different points on the button gets it to print.
ONE SOLUTION OFFERED: "Odds are that you will have to replace the control panel. Or if you are not scared to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.