Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
nec 2010x-t connections
I had the same issue with my inverter. R11 to R14 appeared to be soldered ok, but when I soldered one side, the entire resistor became loose, meaning that there was a cold solder.
Thank you for that tip !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.