Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to test my board in isis but i have to make an map component. Now i want to bain the het code from the map2551 and 2115 which i bought . So i thought connect to willem programmer and read chip. But which chip do iuse in win800? Or does someone has another and better idea ?
Maybe I did not understand the question right? As a Dutchman my English should be good, but I could have misinterpreted the question.
I think it should be a DC. input current is around 80 uA?
Oke that sounds simple ;) For me it is not i guess 8-O
SportDevices. CDI Programmable Digital Ignition.
I found this. But the most of the parts are not defined. Is the 4:50 coil an own winded coil?? How do I do that? Or is this for sale?
Is there a solution to step up from 5V DC to 300V? Or 12V to 300V (DC)?
I found something on this forum as Flyback Inverters... I want to use it to power my CDI.
I am building a Tachometer on IR base. The schematic is ready. But how can I simulate a tachometer (signal). I read something about placing a "Digital Probe"?? But how does one do this??
Also I am writing the code in MicroC. Now I am using a 20 MHz crystal and trying to get every interrupt...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
