Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi echo47 if you see this could you please leave down your email add?
i got to contact you asap regarding your code about the keyboard n monitor.
because i've got to understand it so i can modify it asap.
Thanks alot!
hierarchicaldesignc:18 xilinx
hihi
nope i did not use any partition. im using both ISE 9.1i n XPS 9.1i
i realise that my file was corrupted so i re-created it.
when i implement it, i got back my vv 1st error which was the .bmm file 1
lolssss. omg...
failed to process bmm information
hi!
thanks.. i've try out ur method n the xmp fall under the top(test.v) successfully..
but wen i sythesize it.. wooh! alots of errors
=========================================================================
* HDL Compilation...
edk 10 microblaze submodule
actually i really wld wanna try doing everything in .c code for XPS(EDK) 9.1i
overview of the program is
input -> ps/2 kyboard (key in character)
output-> VGA monitor (character to b display on)
sounds simple rite.. but total haf no idea how to code the VGA...
xilinx xuid
THANKS for the reply:D
i think i get u.. xcept for the last step.. how do u intiate it??
i've follow the steps tt u've suggested.. but unfortunately still the same error.. :(
y???!!
wif reference to the sceenshot below.. is the microblaze_stub be under top (test.v) den counted as...
working with xps and ise
thx for the reply! :)
i'vem tried tt method..
n this is the error msg tt came out
ERROR: found identical ISE and XPS BMM files. Copying the BMM file from the XPS project is no longer needed. Please remove the BMM file from the ISE project.
ani more ideas? do ani1...
ps2_keyboard.v
hello everyone!
1 more step to complete the project.. however this 1 step vv hard to move and haf error!!
i downloaded 2 file(.v) from net, run using ISE
but i haf to make use of MicroBlaze so need to use EDK too
so i tried to create a EDK .xmp file of submodule of ISE but wen...
xps ucf
thx! i've read up on that
but the prob now is.. if i can use ISE's .ucf file in XPS.. izzit the same?
i've actaully tried to add in some codes for pinout in XPS's .ucf file
# VGA port
NET "vga_r" LOC = "R12" ;
NET "vga_g" LOC = "T12" ;
NET "vga_b" LOC = "R11" ;
NET "vga_hs" LOC =...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.