Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The table below is from this document: Schneider RCD
When the maximum response of the device is 40 mS, does it measure current doing RMS or peak detection? The document does not explicitly say it. However, in general, RCDs should trip quick (below 50 ms) when protecting humans. My question is...
I'm using a STM32 Cortex M0+ to read an AC signal from a CT. I'm sampling at 6kHz and storing 400 samples. The signal has a DC bias equal to Vcc/2 = 1.65V. In the digital domain this is 2048. When there's no input signal, I only read the DC bias which is OK. Have a look at the dc_bias_raw.txt...
I'm going through this Reference Design (https://www.ti.com/lit/pdf/tidrlf7) and there is something I don't get. The controller LM5020MM-2 was not designed for primary side regulation, how does this power supply regulate through the auxiliary winding? How precise it is? Does it require certain...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
