Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear All
I have to give one common supply to the two linear regulators. One is TPS74401 and other one has LT3071. One have 16uVrms and other one has 25uVrms noise margin.
Do I need to consider other circuitry to tackle noise? Like use of ferrite bead, inductor and etc
Regards
Bloke203
I tried again as
----------------------------------------------
library ieee;
use ieee.STD_LOGIC_UNSIGNED.all;
use ieee.std_logic_1164.all;
entity recursion_tb is
end recursion_tb;
architecture TB_ARCHITECTURE of recursion_tb is
component recursion
port(
num : in STD_LOGIC_VECTOR(15...
hello FvM
Thanks for your quick reply. I try to write the test bench as
------------------------------------------------------
library ieee;
use ieee.STD_LOGIC_UNSIGNED.all;
use ieee.std_logic_1164.all;
-- Add your library and packages declaration here ...
entity recursion_tb is
end...
Dear Folks
I am looking to understand the code in following link. Also, I want to write a test bench so that I can see the result. i can write the test bench for normal clock, counter etc but i neva face a function.
The link is
VHDL coding tips and tricks: Recursive functions in VHDL
I...
Hello Guys
I know how to change individual sheet size from A4 to A3 or whatever. But I want to change all of my sheets from A4 to A3 at once.
I explain again. I have 17 sheets of size A4. And, I want to change into A3. Is there any way that I can change all of them together. Should I have to...
Hello Guys
I know how to change individual sheet size from A4 to A3 or whatever. But I want to change all of my sheets from A4 to A3 at once.
I explain again. I have 17 sheets of size A4. And, I want to change into A3. Is there any way that I can change all of them together. Should I have to...
Dear Guys
I am looking for some advice how to choose the cap value at VREFCA and VREFDQ. I am using my DDR3 for 40GHz application. Or that amount of data is flushed in and flushed out.
I am using Samsung 4Gb DDR3.
Thanks
Regards
Bloke203
Hello
I assign a net name which was in capital letters. Then I realize, it needs to be in small letters. There were 60 net names , i have to change. So I go to Edit --> Replace Text then I change all of it into smalll letters. But whenever I hover over it, it shows in Capital letter rather than...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.