Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Swapping an old drive for a new model. Motor will run at steady speed input, but mechanics cause the load to cycle on and off 50 times a minute. How do I figure brake resistor size for this application? Not an overhauling load, and not actually braking the motor, just regulating the bus voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.