Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
...and that's why I asked! I knew somebody would come up with a clever solution!
If anybody has any other ideas, I'm wide open, but I think this one should fit the Bill, so to speak.
Thanks a zillion!
/Bill
Gentleones,
I'm going to use a dual-readout EDAC card-edge connector part. Since I'm using Allegro, I'm having a bear of a time trying to figure out how to create the daughter board's card edge connector footprint.
Here's what I've done:
First, I've defined a shape for the actual contact...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
