Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Bigboss,
I am now using a look alike EM model of the six port network simulated in Momentum instead of using S parameter blackbox as you advised earlier.
I am generating non linear noise from Harmonic Balance simulator but my output voltages from the six port network are not affected.
I...
Greeting Everyone!
I have designed and simulated a multilayer six port circuit made up of slot coupled quadrature couplers and dividers in HFSS 3D modeler (ANSYS Electronic Desktop). I used modal analysis and wave ports and achieved good and smooth magnitude and phase results in terms of S...
Thankyou for swift response,
Yes, maybe thats the reason i am not getting any effect on the output voltages even though i am adding phase noise or non linear noise present in HB.
Actually i am sweeping phase in one of the P1tone (simulating phase difference between input signals) and then...
Hi everyone,
I am using ADS and i have modeled a circuit with 2 input ports and 4 output ports using a .s6p file.
I am using P1tone power source with the two input ports.
I am using Harmonic Simulator and S parameter simulation controllers.
At output i am doing analysis on the voltage signals...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.