Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
OK. So I can't get there from here. But can I at least assume the inductance from VCC to the output is about 64nH + 26.4nH = 90.4nH, (see below . I miscalculated previously)? At 433MHz that would be about 246ohm. Shouldn't that be close to the output impedance?
The schematic I attached doesn't...
I bought a 433MHz xmtr/rcvr and I'm trying to match an antenna to it. I know I could use a 1/4wave wire, but I have a Nano VNA and I'd like to try and tune the antenna. The manufacturer does not specify the output impedance, but if I sum the two inductors in the VCC path, as shown in the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
